Pallet book shelf

One of the easiest things we built this year was a book shelf out of a pallet.
Materials that you will need
  1 pallet
   Stain
   Screws

Basically you will just cut the ends off of the pallet leaving 2 boards on one side and 1 board on the other.

Then very carefully remove  2 of the remaining boards from the pallet.  These will be used for the bottom of the shelf.  Screw the boards down. 

Then just sand them down and either paint them or stain them. You can use them any way you like.  We used ours for books but have come across people using them to hold wine bottles. 
And here is the final result:


Comments

Post a Comment

Popular posts from this blog

PVC pipe toddler chair

Image
  These are another simple and cheap DIY project that can be done in a few hours. This project was found at Que Linda.   Our boys love these chairs.  They carry these things around everywhere.    You will need one piece of sturdy fabric such as corduray, denim, or upholstery.  I cut the fabric at 29.5" X 17.5".  I used 1/2" seam allowance.  You can adjust the size of the chair and the fabric just as long as the fabric has enough slack when it's put on the chair.    Once the fabric is cut, fold right sides together hot dog style and sew the long sides together. Then, move the seam so it is in the center and iron seams open. Sew shorter sides together.  Leave a few inches on one side. Turn it inside out through that opening. Then lie it flat and fold the short sides towards the middle on the side of the fabric with the seam.  I folded 3" on each side.  Then sew it down.  I ended up sewing two lines so it would take some wear and tear. After you've m
Read more

Future Projects

Image
I t's been a long time since I posted of any of our projects that we have done but hopefully that will change this summer.  We are planning on doing a bunch of small projects.  A lot of the projects we plan on doing are going to be pallet based. If you have any tips, suggestions, comments, etc please leave comments.  I'm adding a few pics below on some of the ideas that I have found and plan on doing. 
Read more

DIY Pallet Signs

Image
  This one is pretty easy.  We just took a pallet and cut all the boards up into little sections.  Then sand them down.  We used 60 grit followed by 220 grit.   Then, once sanded down.  Either paint or stain them to your liking. Now, if you have stencils you can use those or you can use Microsoft Word (or similar program.) We used word.  We typed in what we wanted on the board.  Made it the size and then the style of font we wanted.  Before you print it off, check your printer settings and see if you can print a mirror image.  Once its printed (should be a mirror image of what's on the computer).  Lay it across the board where you want the words to be.  Take a  paint brush just damp with water and go over where the ink is.  Then use the end of the paint brush and press firmly (not to hard though) to transfer the ink from the paper to the board.  We were then able to paint over the the letters.  The bottom and top pictures are just a couple signs that we have done so
Read more